Specifications

24
4.4. Connecting the Firewire Drive
Important Note: Before connecting the CRW2200FXZ drive and the computer as described below, make
sure that you have installed appropriate CD writing software (P. 38). If you are just installing the CD
writing software, first disconnect all IEEE1394 devices from your computer. After properly installing the
software, you are ready to connect the devices. For information about how to install the software, refer to
the documentation that came with it.
If your computer has no built-in IEEE1394 port, you will first need to install an IEEE1394
interface card (purchased separately). Yamaha recommends IEEE1394 Interface cards
outlined in section 4.2 (page 22). You can purchase IEEE1394 controller cards at your
local computer peripheral retailer or you may contact Yamaha toll-free at 888-926-2426 to
purchase a compatible IEEE1394 controller card. For information about how to install the
card, refer to the documentation that came with it.
Arrow
DC-IN
connector
Screw
1 Turn on the computer
2 Make sure that the power switch on the rear panel of the CRW2200FXZ
drive is set to STANDBY.
3 Connect the included AC adapter to the DC-IN connector of the drive with the
arrow on the adapter plug facing left, as shown below.