User Manual

Table Of Contents

Installation Examples

Suspended Installation Using Eye Bolts (DHR15 and DHR10 only)

Attach commercially available long eye bolts (30–50 mm in length) to the screw holes located at the top (two locations) and on

the lower rear (one location). The screw diameter is M10. Keep in mind that you will need two points at the top to suspend the

unit.

Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support structure or

improper installation.

The screw holes for eye bolts go through the cabinet wall. When not using eye bolts, tighten the flat-head screws in order to prevent air leaks.

CAUTION

• Before doing any installation or construction work, consult with your

Yamaha dealer.

• The installation should be checked thoroughly at regular intervals.

Some fittings may deteriorate over extended periods of time due to

wear and/or corrosion.

• When choosing the installation location, suspension wire and

mounting hardware, make sure all are strong enough to support the

weight of the speaker.

• Make sure to take precautionary measures using wires to prevent the

speaker from falling down in the event of an installation failure.

• When installing the safety wire to the wall, install it higher than the

wire’s attachment point on the speaker, with as little slack as possi-

ble. If the wire is too long, and the speaker happens to fall, the wire

may snap as a result of too much strain.

• Make sure to use eye bolts according to the standards and safety

regulations in your area.

Safety wire can be attached to the screw holes for

eye bolts and to the screw holes for the U-bracket

(DHR10 only) located at the center of the handle.

The illustration below is an example of using the U-

bracket.

NOTE

M10 eye bolt

Max. 45°

Pullback point

 Pullback point

Pullback point

(M10 screw hole)

Lower rear

 Securing the eye bolts

Remove the flat-head screws tightened at the time of factory shipment,

and then insert the eye bolts through the washers when attaching

them.

Apply thread-locking

fluid to the eye bolt

NOTE