Manual

2
7 8
5, 7
7
<To start recording>
1, Press REC.
This unit automatically adjusts the laser strength against the
disc reflection for optimal recording. This process is called
OPC (Optimum Power Calibration) and takes approximately 15
seconds to complete.
The following message appears on the display.
0P'" '-" " " _' _ i
,.. rl (::J..ii,...I:!-5'b -,_.\"__°
J
If this unit determines that OPC is not needed for the disc
loaded, "Standby" flashes on the display.
\ I /
'- i ,::_ -
•_," .!_nl (::jb\ ,I, _
The CDR mark starts flashing in a few seconds and the track
number is indicated on the display. Recording has not been
started yet at this stage. (Recording pause mode)
\ I /
I' _r_ F_EC
.,.+ B:B,:_.,_
• Before starting to record, check the remaining time available
for recording on the CD-R or CD-RW disc. (See page 10.)
2, Select the input source to be recorded.
Press INPUT to select the input source to be recorded from
among OPTICAL, COAXIAL and ANALOG. See page 17 for
details.
3, Adjust the recording level.
The recording level can be adjusted for both digital and analog
input. See page 17 for details.
4. Select the recording mode.
See page 20 for details.
5, Start recording.
Press _>i_D(_>or _Don the remote control) to startrecording,
.L
• In the multi-synchronized, all-synchronized, or full auto-
synchronized recording mode, this unit automatically starts
recording When the source component starts playback.
6, Start playing the source.
7, Press _>/ED(;D on the remote control) to stop recording
temporarily.
"Wait" flashes on the display. The CDR mark starts flashing in
a few seconds and the track number is advanced to the next.
Press _>#D (_> or _Don the remote control) to resume recording.
8, Press D to stop recording.
"Wait" flashes on the display. The number of recorded tracks
and the total recorded time are indicated on the display in a few
seconds, and then the first track number of the recorded tracks
is indicated on the display in a few seconds.
!
i 4 6' _'i7'"
...; "__
!
'i : _
.I. _ _>
E-16