Owner`s manual

4
Install an HDD and Format it
Installation Preparation
1
Prepare the HDD for this unit.
You can use an HDD that meets the following conditions.
Interface: IDE/ATA
Data Transfer Mode: PIO mode 0-4, Multiword DMA mode 0-2
Size: 3.5 inches
Capacity: 20 GB-400 GB (Up to 400 GB is recommended; more than
400 GB may not be operable.)
Estimated recordable time for each HDD capacity is as follows.
Capacity Available Time
80 GB approx. 120 hrs.
160 GB approx. 240 hrs.
200 GB approx. 300 hrs.
320 GB approx. 480 hrs.
400 GB approx. 600 hrs.
For information on compatible HDDs, please contact your nearest
authorized Yamaha branch or dealer.
■
2
Turn off the power of this device and disconnect the power
cord from the electrical outlet.
3
Disconnect this device from other devices.
4
Set the HDD to “Slave.”
■
NOTE
Always set the HDD to “Slave”
when you use with this device.
Refer to the manual supplied
with the HDD, or ask the HDD
manufacturer how to set it to
“Slave.”
NOTE
Always set the HDD to “Slave”
when you use with this device.
Refer to the manual supplied
with the HDD, or ask the HDD
manufacturer how to set it to
“Slave.”
Getting Started
Installing an HDD (Hard Disk Drive)
To use the recording function of the CDR-HD1500, you need to install an HDD.