User manual

Command line index
iXOS-JUKEMAN 2.2 User Manual Pre.12/97226
cdadm remove [-f] <device> [<list>]
cdadm export [-f] <device> [<list>]
Function:
Remove a volume from the specified device.
The parameter <device> represents a valid device description file in the
JUKEMAN directory. These files have the extension .dev. The extension
may be omitted in the command.
The optional <list> parameter may be used to specify any number and
selection of slots. The following syntax is used to specify a variety of slots:
7
slot 7
3,6,40
slots 3, 6 and 40
3-7
slots 3 through 7
2,20-45
slots 2 and slots 20 through 45
(no specification): all slots available.
(As an alternative for the slot number, a disk name may be specified.)
The slot range will be scanned for occupied slots and a single volume will
be removed from the first found occupied slot. If there are no occupied
slots, you will get an error message.
Note that for some devices like single drives and towers there is a dy-
namic drive check to detect disk changes (see server parameter dcheck
in section “Server parameters” on page 123). You do not need to issue
this command if you want to remove disks from these devices.
The optional -f switch can be used with the Pioneer DRM-500 and the
Grundig GMS 1035. Using this switch, the command will return as soon as
the door may be opened for a disk to be removed. This is to prevent you
from opening the jukebox door too early. If the switch is not specified, the
command will wait, until the disk change is finished.
Example:
cdadm remove merc 2,5,6
Error messages:
Error message Meaning
No such device
*error* 19
Specified device does not exist or
is not attached.
remove
export