User manual

Set up devices
iXOS-JUKEMAN 2.2 User Manual Pre.12/97 57
device=pioneer18 device=pioneer18
drive=\\.\p0b0t3 drive=/dev/iXOS_SCSI0/3
robot=\\.\p0b0t3,1 robot=/dev/iXOS_SCSI0/3,1
disks=1-9 disks=1-9
For the “kubik”, the robot uses a serial interface. The device description
file looks like this:
device=kubik device=kubik
drive=\\.\p0b0t1 drive=/dev/iXOS_SCSI0/1
drive=\\.\p0b0t2 drive=/dev/iXOS_SCSI0/2
drive=\\.\p0b0t3 drive=/dev/iXOS_SCSI0/3
drive=\\.\p0b0t4 drive=/dev/iXOS_SCSI0/4
robot=com2: robot=/dev/ttya
For NSM jukeboxes “cdr100”, “mercury”, and “satellite”, a single serial line
controls up to 16 jukeboxes. An additional line robid=<id>, specifies the
ID of the robot on the serial line. Each NSM jukebox has an ID from 0 to
15, which can be checked and set by the Mercury’s or Satellite’s menu, or
directly in the CDR 100 (see NSM manual). A device description file for a
Mercury 20 with Robot ID 7 should look something like:
device=mercury device=mercury
drive=\\.\p1b0t0 drive=/dev/iXOS_SCSI1/0
drive=\\.\p1b0t1 drive=/dev/iXOS_SCSI1/1
robot=com2: robot=/dev/ttya
robid=7 robid=7
Alternatively, the following syntax can be used to define the serial inter-
face and robot ID in one line:
robot=com2:,7 robot=/dev/ttya,7
3.4.5 Further points to note
Make sure the device to be set up is connected properly and operational.
Note: The section “Supported jukeboxes” on page 163 provides you with
more specific details about the supported jukeboxes with sample
device description files, that can be used with minor modifications.