User manual

Set up views
iXOS-JUKEMAN 2.2 User Manual Pre.12/97 73
new view and confirm with 'RETURN'. If a view is to contains subviews
contains views must be selected for this view. Otherwise click contains
volumes.
Renaming a view:
Select the corresponding view and click [RENAME], or double-click the
view. Enter a new name and press 'RETURN'.
Removing a view:
Please note that all subviews will be lost, if a view is deleted. Select the
appropriate view and click [REMOVE].
Assign a view a drive letter:
Select a view and a drive letter from the list Available as Drive. The drive
letter can then be shared to the clients. If you select [none] wählen, the
view will not be assigned a drive letter. Please note, that executables
cannot be started from these drive letters on the server. To do this,
the corresponding drive must additionally be mapped as a network drive
on the server. This can be easily done with the Windows NT Explorer.
Setting up disk sets for a view:
The field visible volumes lists all disk names visible to the clients (all by
default). The field excluded volumes lists all disk names, that will not be
visible to the clients explicitly (none by default).
The specification can either be as meta characters in csh syntax (see
“Table 4” on page 69) or explicitly by specifying a blank separated list of
disk names. The [CONTENTS] dialog lists the disk names. Please note
that the name must be entered in the correct name format. As opposed to
the original disk name, the disk name in one of the three name formats is
always unique.
Confirming or discarding the views set-up:
Click [OK] to confirm the views set-up.
Click [CANCEL] to discard the changes.
Please note:
If you change a view name the changes will not be active unless
'RETURN' is pressed. In some cases the [OK] button can only be clicked
if you click somewhere else in the view tree (e. g. Root).