Owner's Manual

CL Editor Owner’s Manual

7 RATIO

Specifies the ratio (the amount of compression.)

8 WIDTH

Specifies the width between the threshold level of the compressor (THRESHOLD) and the threshold level of the

expander.

9 ATTACK

Specifies the time (the attack time) until it starts to compress and expand the input signal once the compander has been

triggered.

0 GAIN

Adjusts the gain of the signal after it has passed through the compander.

A RELEASE

Specifies the time (the release time) from when the key-in signal falls below the threshold level until compression and

expansion are removed.

B KEY IN SOURCE

Click this to select the key-in signal that you want to use.

The choices are the same as for GATE.

If DE-ESSER is selected

1 TYPE

This indicates that De-Esser is the currently selected type.

2 LIBRARY

This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the Library window.

3 ON

This button switches the de-esser on/off.

4 Response curve

Indicates the response for the de-esser of the currently selected channel.

5 GR meter (Gain Reduction meter)

This meter indicates the amount of gain reduction produced by the de-esser.

6 THRESH (Threshold level)

Specifies the threshold level at which the de-esser will operate. The input signal will start being compressed when the

key-in signal exceeds this level; compression will be removed when the signal falls below this level.

7 FREQ (Minimum frequency/Center frequency)

Specifies the minimum frequency (for HPF) or the center frequency (for BPF) at which the key-in signal will activate

the de-esser.

235