Owner's Manual

CL Editor Owner’s Manual

❏ EQ (Equalizer)

1 LIBRARY

Accesses the OUTPUT EQ page of the Library window.

2 ON

Switches the EQ on/off.

3 EQ graph

Indicates the response for the EQ of the currently selected channel. To reset the EQ to flat response, hold down the

<Ctrl>(< >) key of your computer keyboard and click the graph.

4 Q

These knobs adjust the Q level of the frequency range selected in the EQ graph.

5 FREQ (FREQUENCY)

These knobs adjust the center frequency for the four bands LOW, LO-MID, HI-MID, and HIGH.

6 GAIN

These knobs adjust the Q, center frequency, and boost/cut amount for the four bands LOW, LO-MID, HI-MID, and

HIGH.

7 HIGH shelving

If this button is on, the HIGH EQ will be switched to a shelving type (the Q knob of the HIGH EQ will disappear.)

8 LPF (Low Pass Filter)

If this button is on, the HIGH EQ will function as a low pass filter. The Q knob of the HIGH EQ will disappear, and the

GAIN knob will act as the low pass filter on/off switch.

9 (LOW shelving)

If this button is on, the LOW EQ will be switched to a shelving type (the Q knob of the LOW EQ will disappear.)

0 HPF (High Pass Filter)

If this button is on, the LOW EQ will function as a high pass filter EQ. The Q knob of the LOW EQ will disappear, and

the GAIN knob will act as the high pass filter on/off switch.

A TYPE I/TYPE II (EQ type)

Selects either TYPE I or TYPE II as the EQ type.

B ATT (Attenuation)

Adjusts the amount of attenuation for the signal level of pre EQ.