Owner's Manual

CL Editor Owner’s Manual
94
In the Outport Setup window you can assign the source channel for each output port and set the parameters.
The window includes the following items.
1 Output port select tabs
These tabs switch the output ports controlled in the window in groups of up to eight ports.
2 DELAY SCALE field
Here you can select the units for the delay time shown below the delay time knob (8). If the RECORDER tab is
selected for the Output port select tabs (
1), the DELAY SCALE field will be hidden in the screen.
• meter (343.59m/s)
The delay time is shown as a distance in meters, calculated as the speed of sound (343.59 m/s) at an air temperature
of 20°C (68°F) multiplied by the delay time (seconds.)
• feet (1127.26ft/s)
The delay time is shown as a distance in feet, calculated as the speed of sound (1127.26 feet/s) at an air temperature
of 20°C (68°F) multiplied by the delay time (seconds.)
•sample
The delay time is shown as a number of samples. If you change the sampling frequency at which the CL operates,
the number of samples will change accordingly.
•ms
The delay time is shown in units of milliseconds.
3 Output port
This indicates the type and number of the output port to which the channel is assigned.
4 Channel select
This area lets you select the channel that is assigned to the output port.
5 Channel name
Indicates the name of the channel that is assigned to the corresponding output port.
6 DELAY button
Switches the output port delay on/off.
7 Delay time
The millisecond delay time value is shown above the knob.
The delay time value in the units selected in the DELAY SCALE field (
2) is shown below the knob.
Click the
▲/▼ buttons to make detailed settings.
Outport Setup window
1
2
3
5
6
78
9
0
A
4