User Manual

CL Editor Owner’s Manual

❏ BALANCE

This is shown only if the selected MATRIX bus is being used as stereo. It

adjusts the left/right volume balance of the stereo signal. You can set this to the

center value by holding down the <Ctrl>(< >) key of your computer key-

board and clicking this knob.

❏ EQ (Equalizer)

This is the same as for the equalizer of a MIX channel (➥ p.48.)

❏ DYNAMICS1

Except for the fact that the available types are COMPRESSOR, EXPANDER, COMPAND H and COMPAND S, and that

you can select more than one signal as the key-in signal, this is the same as the dynamics for input channels (➥ p.38.)

❏ INSERT

Except for the fact that the insert ports that can be selected are different, this is the same as for the insert settings of an

input channel (➥ p.43.)

❏ RECALL SAFE/MUTE SAFE

These are the same as the RECALL SAFE/MUTE SAFE functions for input channels (➥ p.44.)

❏ DCA GROUP/MUTE GROUP

These are the same as the DCA GROUP/MUTE GROUP functions for input channels (➥ p.45.)

❏ Fader

1 ON

This switches the MATRIX channel on/off.

2 Fader

This adjusts the output level of the MATRIX channel. A meter indicating the signal level is

shown at the right of the fader, and the current value is shown in the numerical box imme-

diately below. You can set this to the minimum value (–∞ dB) by holding down the

<Ctrl>(< >) key of your computer keyboard and clicking the fader knob, or set it to the

nominal value (0.00 dB) by holding down the <Ctrl>(< >) key and <Shift> key and click-

ing the fader knob.

3 CUE

This button cue-monitors the signal of the MATRIX channel.

In the ONLINE state, if MATRIX bus channels 7 and 8 can be used as a second cue, the

indication shows “CUE A,” “CUE B,” or “CUE AB” depending on the settings of the console.

If the Channel Select/Sends On Fader checkbox in the System Setup dia-

log box is not checked, the [CUE] button will be hidden in the screen.

NOTE