User Manual
Table Of Contents
- ■ Precautions (Please be sure to read this section first!)
- ■ Checking the version number
- ■ Preparing for the update
- ■ Update procedure sequence
- ■ Install the Dante Firmware Update Manager
- ■ Computer TCP/IP setting (for R series device)
- ■ Computer TCP/IP setting (for Dante)
- ■ Error Message List (RSio64-D Update Program V3)
12
10. Click [Start].
The update operation will begin.
“Updating(n/m)” appears in the Status field during updating. “Done” is displayed once update is completed.
Update takes 2 to 4 minutes. During the update operation, do not turn off the power to the device or disconnect
the cable. If update fails due to disconnection of the power cable during the update, or due to other reasons, the
device may become inoperative.
・If update is not completed after 5 minutes, or update failure indication appears, click X at the upper right
corner of Dante Firmware Update Manager to exit the program without turning the device power off, and restart
the procedure from the step 4. If update still fails, follow the instructions stated in “About Failsafe Mode” to
perform the recovery process.
11. Turn off the power to the R series device and return the dip switches to their original settings.
Please return the dip switch settings to the positions noted in step 2 of the "Updating the R series firmware."
The firmware update is now complete.