User Manual

Grouping and linking
V2.0 Supplementary Manual
6
1 ROLL-OUT BLOCK
Enables you to select a block in which the DCA group is rolled out to the faders.
CL5 : Blocks A, B, C
CL3/CL1 : Blocks A, B
2 ALIGN button
Enables you to choose whether the DCA group is rolled out to the faders from the left or right.
3 DCA group select button
Selects the DCA group that you want to control.
4. Select the DCA group that you want to control.
If you press a [SEL] key for a DCA group other than the selected one, the group selection will
change.
5. Select a block (in which the DCA group is rolled out to the faders) and the
alignment.
6. Press the CLOSE button to close the popup window.
NOTE
You cannot turn DCA Roll-out mode on if one of the following popup windows is open. If DCA
Roll-out mode is already turned on, opening one of the windows will cause DCA Roll-out mode
to quit.
- DCA/MUTE GROUP ASSIGN MODE popup window
- RECALL SAFE MODE popup window
Added DCA output channels
You can now assign the Stereo/Mono bus master, Mix bus master, and Matrix bus master channels to a
DCA group.
DCA groups were formerly used exclusively for input channels. However, with this new feature, you can
use the DCA groups for output master channels, which enables for more flexible simultaneous controls.
1. In the Function Access Area, press the CH JOB button.
2. Press the DCA GROUP button to access the DCA/
MUTE GROUP ASSIGN MODE popup window.
3. Use the DCA GROUP select buttons to select the DCA group to which you want to
assign channels.
4. Press the [SEL] key for the output channel to select the channel that you want to
assign.
5. When you finish assigning the channels, press the CLOSE button to close the
popup window, then press the “x” symbol in the Function Access Area (CH JOB
display).
2
1
3
DCA GROUP
button
DCA GROUP
select button