User Manual

ShureWirelesswithYamahaCL/QL

www.yamahaproaudio.com

Now, when the chosen input port is patched to an input channel, the wireless

receiver settings will be shown on that channel. In the example below, a QLXD4 is

assigned to Dante port 3, which is patched to input channel 3. And an AXT400

receiver is assigned to Dante port 5, which is patched to input channel 5.

Notice that both the input’s A.GAIN and the wireless receiver’s gain/level are shown

in the GAIN / PATCH pop-up window, if the assigned port has a Head-Amp. So the

A.GAIN function would be missing if an AES/EBU connection was used from

AXT400.

The QLXD4 and ULXD4 devices have the RX.GAIN function, while AXT400 has

TX.GAIN and RX.LEVEL. TX.GAIN is the “transmitter gain”, and can only be

controlled if the Shure ShowLink® function is active (which is available only when

the ShowLink® access point is connected in the AXT system).

Up to 4 CL/QL consoles can be used in the same network to control these Shure

wireless devices. Give each CL/QL console a different ID number in the DANTE

SETUP menu.