User Manual
Table Of Contents
- ■ Precautions (Please be sure to read this section first!)
- ■ Checking the version number
- ■ Preparing for the update
- ■ Update procedure sequence
- ■ Install the Dante Firmware Update Manager
- ■ Computer TCP/IP setting (for R series device)
- ■ Computer TCP/IP setting (for Dante)
- ■ Error Message List (RSio64-D Update Program V3)
16
13. Exit the Dante Firmware Update Manager, and wait for two minutes before turning off the power to
the R series device.
After recovery, restart the Dante module. If you power-off the R series device before restart is completed, the data
of the Dante module will be corrupted, and you will have to perform the recovery once again. Start Dante
Controller, and if the device name is shown in black, it is safe to turn off the power.
14. The correct Dante firmware now needs to be loaded.
After recovery, the Dante firmware will not be the latest version. To update to the latest firmware, perform steps
2 through 11 of "Updating the Dante firmware."
Now recovery and firmware update are completed.