User Manual

Yamaha Commercial Audio
Dante-MY16-AUD HA Remote Control Guide
6 www.yamahaproaudio.com
Equipment List
1. Yamaha digital mixer (PM5D/PM5D-RH, M7CL-32/48, M7CL-48ES,
LS9, DM2000, DM1000) or digital mixing engine (DME64N/24N)
2. Dante-MY16-AUD card (firmware v3.3.9 or later)
3. Dante-compatible Yamaha HA equipment (Rio3224-D, Rio1608-D, Ri8-
D, etc.)
4. PC or Mac where Dante Controller v3.2.9 or later is installed
5. Gigabit network switch, network cable of CAT5e or better
6. D-sub 9-pin straight serial cable (male–female)*
*Precautions for a serial cable:
・ This is not required when you control the HA via the Dante network from
the M7CL-48ES, the LS9, or the CL series. To control the HA from another
digital mixer, a serial cable is required. Moreover, it is required when you
control such HA equipment as the AD8HR from the REMOTE terminal of
the Dante-MY16-AUD card.
・ The serial cable to use is a D-sub 9-pin straight cable, of male–female type.
As an alternative, you can use a straight cable of female–female type with
a gender changer (conversion adapter) of male–male type.
or
Female
Male
Straight
Straight
Straight
Female
Female
Male - Male