User Manual

Owner’s Manual
17
Editing the user pattern
Editing the user pattern
The user pattern lets you freely specify the routing between
Dante and the slots.
To edit the user pattern, use R Remote V4 or a CL/QL series
console.
For details, refer to the respective manuals.
About R Remote V4
This is an application that lets you view and edit the
settings of R series units such as the RSio64-D.
R Remote V4 can be downloaded from the following
website.
http://www.yamahaproaudio.com/
About the number of input/
output channels
The number of audio input/output channels is as follows.
Slots
The slots can provide up to 64 channels (16 channels per
slot) of audio signal input/output.
NOTE
• If an analog Mini-YGDAI card is installed and the
corresponding slot’s SRC is turned on, that slot uses the
RSio64-D’s internal 48 kHz clock.
• If this unit’s sampling frequency is set to 88 kHz or 96 kHz,
and you want to install a Mini-YGDAI card that does not
support 88.2 kHz or 96 kHz, you should turn SRC on for that
slot. If SRC is off, audio signals will not be output.
Dante
NOTE
To change the Dante clock frequency, use Dante Controller.
Frequency Input Output
44.1 kHz 16 ch 16 ch
48 kHz 16 ch 16 ch
88.2 kHz 8 ch 8 ch
96 kHz 8 ch 8 ch
Frequency Input Output
44.1 kHz 64 ch 64 ch
48 kHz 64 ch 64 ch
88.2 kHz 32 ch 32 ch
96 kHz 32 ch 32 ch