User Manual
Table Of Contents
- Cover
- Contents
- Introduction
- Controls and Connectors
- Panel Operations
- Basic Operations
- Screen Structure
- Operations that can be Performed from the Panel
- Alert Messages
- HOME Screen
- METER Screen
- SETTING Screen
- UTILITY Screen
- MENU Screen
- SIGNAL PATH Screen
- SIGNAL PATH Block Diagrams
- Recalling library settings (Speaker Processor only)
- Slot Input Router
- Input On/Off
- 4x4 Matrix Mixer
- 8Band Input EQ
- Input Delay
- Oscillator Mix
- X-Over Input Level (Speaker Processor)
- X-Over Polarity (Speaker Processor)
- X-Over (Speaker Processor)
- Output Delay (Speaker Processor)
- 6Band Output EQ (Speaker Processor)
- Output Level (Speaker Processor)
- Mute On/Off (Speaker Processor)
- Limiter (Speaker Processor)
- Output Router
- SCENE Screen
- Initializing the internal memory
- System Connection Examples
- Connecting External Controllers and Analog Devices
- Adjusting the Input/Output Levels
- Appendix
TX6n/5n/4n Reference Manual
23
Panel Operations
● Setting the Lock
1. Use encoder A to move the cursor to the lock that you want to set, and use encoder B to change the setting.
The parameter you switched will blink.
2. Press the [ENTER] button. The lock will be applied.
● Temporarily defeating panel lock
Here’s how you can temporarily defeat the panel lock. Even if the lock is temporarily defeated, it will again be set the next time
the power is turned on.
• If you want to clear panel lock, defeat the lock as explained below, and then set Panel to Normal.
1. Simultaneously hold down the [HOME] button and [EXIT] button for at least three seconds.
A message of “Unlock panel” will appear.
2. Press the [ENTER] button.
Panel lock will be temporarily (until the power is turned on again) defeated.
■ Scene Setup
Here you can make settings related to scene recall.
Parameter name Range Explanation
Scene Recall Enable/Disable Specifies whether scene recall via front panel operations will be
allowed. This will not affect control from an external device such as Amp
Editor.
EMG Scene Setup OFF, 00–49 Specifies the scene number that will be recalled when the EMG (Emer-
gency) signal is received from an external controller. If this is OFF, a
scene will not be recalled even if an EMG signal is received.
Last Memory Resume ON/OFF Specifies what will happen when the power is turned on. If this is ON,
the unit will start up with the settings that were in effect when the power
was last turned off. If this is OFF, the unit will start up by recalling the
scene of the scene number that was being used when the power was
last turned off.
NOTE