User Manual
Table Of Contents
- Cover
- Contents
- Introduction
- Controls and Connectors
- Panel Operations
- Basic Operations
- Screen Structure
- Operations that can be Performed from the Panel
- Alert Messages
- HOME Screen
- METER Screen
- SETTING Screen
- UTILITY Screen
- MENU Screen
- SIGNAL PATH Screen
- SIGNAL PATH Block Diagrams
- Recalling library settings (Speaker Processor only)
- Slot Input Router
- Input On/Off
- 4x4 Matrix Mixer
- 8Band Input EQ
- Input Delay
- Oscillator Mix
- X-Over Input Level (Speaker Processor)
- X-Over Polarity (Speaker Processor)
- X-Over (Speaker Processor)
- Output Delay (Speaker Processor)
- 6Band Output EQ (Speaker Processor)
- Output Level (Speaker Processor)
- Mute On/Off (Speaker Processor)
- Limiter (Speaker Processor)
- Output Router
- SCENE Screen
- Initializing the internal memory
- System Connection Examples
- Connecting External Controllers and Analog Devices
- Adjusting the Input/Output Levels
- Appendix
TX6n/5n/4n Reference Manual
35
Panel Operations
■ Oscillator Mix
This is a mono-channel oscillator. It generates a sine wave, pink noise, or burst noise. This can also mix the audio input signal
and oscillator signal.
■ X-Over Input Level (Speaker Processor)
This adjusts the input level to the crossover in a range of -∞ – +10 dB.
■ X-Over Polarity (Speaker Processor)
This specifies the phase reversal of the input signal to the crossover.
Parameter name Range Explanation
PGM To SP ON/OFF Switches on/off the input from the Input Delay to the mix point before
the Speaker Processor.
Osc To SP ON/OFF Switches on/off the input from the oscillator to the mix point before the
Speaker Processor.
Osc On ON/OFF Turns the oscillator on/off.
Osc Level -∞ –0.00 dB Specifies the output signal level.
Wave Form SINE100 Hz,
SINE1 kHz,
SINE10 kHz,
PINK, BURST, Vari
Selects the waveform that will be generated. If you select SINE (sine
wave), you can also select a frequency. If you want to freely specify the
frequency of a sine wave, select Vari.
Vari Freq 20.0 Hz–20.0 kHz If you selected Vari as the Wave Form, this specifies the frequency of
the sine wave that will be generated.