User Manual
Table Of Contents
- Cover
- Contents
- Introduction
- Controls and Connectors
- Panel Operations
- Basic Operations
- Screen Structure
- Operations that can be Performed from the Panel
- Alert Messages
- HOME Screen
- METER Screen
- SETTING Screen
- UTILITY Screen
- MENU Screen
- SIGNAL PATH Screen
- SIGNAL PATH Block Diagrams
- Recalling library settings (Speaker Processor only)
- Slot Input Router
- Input On/Off
- 4x4 Matrix Mixer
- 8Band Input EQ
- Input Delay
- Oscillator Mix
- X-Over Input Level (Speaker Processor)
- X-Over Polarity (Speaker Processor)
- X-Over (Speaker Processor)
- Output Delay (Speaker Processor)
- 6Band Output EQ (Speaker Processor)
- Output Level (Speaker Processor)
- Mute On/Off (Speaker Processor)
- Limiter (Speaker Processor)
- Output Router
- SCENE Screen
- Initializing the internal memory
- System Connection Examples
- Connecting External Controllers and Analog Devices
- Adjusting the Input/Output Levels
- Appendix
TX6n/5n/4n Reference Manual
42
Panel Operations
■ Editing a scene
Here’s how to edit the scene name or turn the protect setting on/off for each scene 01–49.
1. In the HOME screen, press the right-most function button (SCENE) to access the SCENE screen.
2. Use encoder A to select the scene number that you want to edit.
3. Press the second function button from the right (EDIT).
The same confirmation screen as for Scene Store will appear.
Then edit the scene name or protect setting in the same way as when storing a scene, and when you are finished press the
[ENTER] button to execute your edits (page 41).
■ Erasing a scene (Clear)
Here’s how to clear a scene 01–49. However, you cannot clear the current scene.
1. In the HOME screen, press the right-most function button (SCENE) to access the SCENE screen.
2. Use encoder A to select the scene number that you want to clear.
3. Press the right-most function button (CLEAR).
The Scene Clear confirmation screen will appear.
• If the current scene is selected, [CLEAR] will not appear because the current scene cannot be erased.
4. Press the [ENTER] button to execute the Clear operation.
• While settings are being applied to the amplifier, the message “Do not turn off!” will be shown in the display.
Never power-off the amplifier while this message is displayed.
NOTE
CAUTION