User Manual

Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
153
 [Close All Editor Windows]
Closes all of the editor windows.
 [Device Properties...]
Opens the Device Properties window (page 127).
 The context menu in Design mode
Of the items in the Operation mode context menu, [Peak Hold] and [Level Meter Enable] are not shown.
Snap
This function temporarily memorizes the parameter settings of the component editor. When you click a snap but-
ton, all parameters of the editor will switch to the parameter set that was stored in that button. At this time, the
parameter set prior to this change will be stored in the snap button that had been selected before the switch. When
you recall a library item (page 155), the library item’s parameter set will be stored in the snap button that is
turned on at that time.
• The snap settings are not saved in the library or project folder. The snap settings will be discarded when
you exit Amp Editor or close the project.
• When you use the snap buttons to switch parameter sets, parameters for which local link is enabled will
change in tandem, but global link will not operate.
 Snap buttons ([A]–[D] buttons)
These buttons switch parameter sets. The appearance of the button will change depending on their on/off state
and on whether there has been a change from the parameter set at the time the editor was started.
 Buttons whose parameter set has not been modified since the editor was started
The button will light when you select it.
NOTE