User Manual

Chapter 5 Main panel window
Amp Editor Owner’s Manual
74
 GPI OUT
For each port, you can specify a device’s parameter whose state will be output from GPI OUT. The column at
the far left indicates the port number.
 Function
Specify the function whose state will be output from GPI OUT. You can select one of seven functions: [No
Assign], [Scene Recall], [Mute], [Standby/On], [Parameter Value Edit], [Direct Parameter Value] and
[Alert]. The editable content of [Device], [Parameter], [Threshold], [Polarity], and [Output Type] will
change according to the function you select.
[No Assign]
No function will be assigned, and nothing will be output from GPI OUT. This is the default value.
You can use [Output Type] to specify only the polarity of the output signal during an alert occurrence.
The [Device], [Parameter], [Threshold], and [Polarity] fields are unavailable.
[Scene Recall]
The recall status of the specified scene will be output from GPI OUT. Use [Device] to select the appro-
priate amplifier. If you select “ALL,” all amplifiers connected to that device will be selected.
Use [Parameter] to specify the number of the scene whose recall status will be sent from GPI OUT.
[Threshold] and [Polarity] are unavailable. [Output type] specifies how the voltage to GPI OUT will be
output.
Output Type GPI OUT output
Closed will be output if the current scene is the same scene specified by [Parame-
ter], and Open will be output otherwise.
Open will be output if the current scene is the same scene specified by [Parameter],
and Closed will be output otherwise.
The output will briefly change (for 250 msec) from Open to Closed if the current
scene is the same scene specified by [Parameter].
The output will briefly change (for 250 msec) from Closed to Open if the current
scene is the same scene specified by [Parameter].