User Manual

RMio64-D Owner’s Manual
9
9 WORD CLOCK [Fs] indicator
Displays the word clock frequency that the unit is
using. This indicator flashes if no word clock is
synced.
) Dante [SYSTEM] indicator
Displays the operating status of the unit.
! Dante [SYNC] indicator
Displays the sync status between the Dante network
and this unit.
@ [EXTERNAL CONTROL] indicator
This indicator turns on when a parameter which can
be operated only from an external remote control is
effective.
For details about parameters that can be operated
by remote control, see “Remote Control” (page 16).
# Power indicator
[I]/[P] (Power Switch)
Turns power of the unit to on [I] or off [P].
The indicator turns on when AC power is on.
CAUTION
Even when the power switch is turned off, a small
amount of current is flowing through the unit. When you
are not using the product for a long time, make sure to
unplug the power cord from the AC outlet.
NOTE
Rapidly turning the unit on and off in succession can cause
it to malfunction. After turning the unit off, wait for at least 6
seconds before turning it on again.
Rear Panel
$ AC IN connector
Connect the supplied AC power cord here. First
connect the AC power cord to the RMio unit, then
insert the power cord plug into an AC power outlet.
The supplied AC power cord features a V-lock
mechanism via a latch, which prevents the power
cord from coming off accidentally.
Insert the cable plug all the way until it locks in
securely.
CAUTION
Be sure to turn the power off before connecting or
disconnecting the power cord.
Press the latch button on the plug to disconnect the
power cord.
% Dante [PRIMARY] connector
Dante [SECONDARY] connector
These are etherCON (RJ-45) connectors for
connecting to the Dante network.
NOTE
• Use STP (Shielded Twisted Pair) cable to prevent
electromagnetic interference. Make sure that the metal
parts of the plugs are electrically connected to the STP
cable shield by conductive tape or comparable means.
• Connect only Dante-compatible devices or GbE-
compatible devices (including a computer).
• Cables of up to 100 meters (theoretical value) can be
used.
Green
(indicator lights)
The unit is working properly.
Green
(indicator flashes)
The firmware updating is in
progress.
Red
(indicator lights)
The memory on the unit does not
work properly.
Red
(indicator flashes)
An error has occurred in the Dante
module.
Green
(indicator lights)
The device is working as the slave
on the Dante network.
Green
(indicator flashes)
The device is working as the
master on the Dante network.
Orange
(indicator lights)
Synchronization with the Dante
network is in progress.
Orange
(indicator flashes)
The device is not synchronized
with the Dante network.
$^& * B C(% A D E