User Manual

CL Editor Owner’s Manual

If a MIX channel is selected

❏ CHANNEL SELECT (Channel selection)

1 SELECT (Channel selection)

Except for the fact that your editing applies to a MIX channel, this is the

same as the channel selection for an input channel (➥ p.32.)

2 LIBRARY

Accesses the Output Channel Library. Click this button to open the

OUTPUT CH page of the Library window.

3 PATCH (Output patch)

Selects the output source assigned to the Mix channel (for the selectable

output sources, ➥ p.23.)

If multiple patches have been made, only the first port is shown.

❏ TO MATRIX

1 MATRIX send level

This adjusts the send level of the signal sent from the MIX channel to the MATRIX buses.

2 PRE (PRE on/off)

Select either PRE or POST as the position from which the signal is sent from the MIX

channel to the MATRIX bus. PRE EQ or PRE FADER is selected if this is on, or POST

FADER is selected if this is off. The PRE EQ/PRE FADER setting can be made in the Mixer

Setup dialog box.

You can right-click (<control> key + click) the PRE button to display a context-sen-

sitive menu that will enable you to specify ALL PRE, ALL POST, or other options.

• If you are using MATRIX buses in stereo,

the knob for the odd-numbered bus will be

PAN or BALANCE.

• The stereo/mono status can be specified in

the Mixer Setup dialog box.

3 ON (MATRIX send on/off)

This is an on/off switch for the signal sent from the MIX channel to the MATRIX bus.

4 Channel name

This section indicates the MATRIX channel name.

1 2

NOTE

HINT

Knob of odd-numbered side