User Manual

Yamaha Professional Audio CL StageMix V7 User Guide
Page 48
If you have accessed the 8-Band PEQ Editor from the Rack screen,
press the [X] button in the upper right corner to return to the Rack
screen.
5.5 PAN TO STEREO BUSSES
When PAN mode is selected using the buttons described in section 5.0, all 8
thumbnail images will display a slider showing the position of the Pan to the
Stereo Busses for each channel. A numeric Pan position value appears
above each slider.
Double-tap on the slider to set the Pan position to Center.
Text shows whether each channel is assigned to the ST, Mono or the LCR
busses.
• “ST” is displayed in red if the channel is assigned to the Stereo bus.
• “M” is displayed in yellow if the channel is assigned to the Mono bus.
• “LCR” is displayed in white if the channel is assigned to LCR.
Tap on these text labels to open a popup that will allow assignments to these
busses to be edited.
5.5.1 Balance
Stereo Inputs 1-8 can be assigned to either Pan or Balance mode in the
CL series console. “BAL” will be displayed below the pan slider when a
Stereo Input channel is in Balance mode. The pan slider is used to
adjust the Balance.
When “BAL” is not displayed, Stereo Input channels are in normal Pan
mode. The Pan position for the left and right sides of the Stereo Input
channel can be adjusted independently in Pan mode. A button
displaying [L] or [R] will appear above the Pan slider in this mode.
Press this button to toggle between the Left and Right sides of the
Stereo Input channel to adjust the Pan position for each side.
Mix and Matrix Busses provide a Balance control when they are
configured as stereo pairs. “BAL” will be displayed below the pan slider
when a Mix or Matrix Bus is configured as a stereo pair.