User Manual

10.24. "RM Series Settings" > "Enable SCP remote control access" dialog
box
To open this dialog box, click [RM Series Settings] from the [System] menu on the menu bar, and then click
[Enable SCP remote control access].
To be able to modify the settings via a controller (such as ProVisionaire Design), you must turn on the “Enable
SCP remote control access” setting.
• Device List
◦ Unit ID / Model / Device Name
These columns indicate the device Unit ID, device model name, and device name.
To change the device name, use the [Device Name] field in the “Properties” area of the “Project”
sheet.
•
[All ON] button
Selects all devices.
•
[All OFF] button
De-selects all devices.
•
Check box
If you add a check mark to this check box and click the [OK] button, the “Enable SCP remote control
access” setting will be enabled.
•
[OK] button
Enables the setting and closes the dialog box.
•
[Cancel] button
Discards the setting and closes the dialog box.
10. Dialog boxes
100 | ProVisionaire Design User Guide