Musical Instrument Owner's Manual

Detailed Settings – [FUNCTION]
CLP-370/340/330, CLP-S308/S306 Owner’s Manual
ENGLISH
67
You can change the volume of the metronome
sound.
Use this function to adjust the metronome vol-
ume.
1. Engage the Function mode and select
(CLP-370/340)/ (CLP-S308/S306, CLP-
330).
2. Use the [–/NO] and [+/YES] buttons to set the
metronome volume as required.
Setting range: 1 – 20
Normal setting: 10
You can make detailed adjustments to MIDI
settings.
For more information about MIDI, see the
“About MIDI” section (page 72).
1. Engage the Function mode and select
(CLP-370/340)/ (CLP-S308/S306, CLP-
330).
2. Press the [+/YES] button to engage the MIDI
function’s sub-mode, then use the [TEMPO/
FUNCTION , ] buttons to select the
desired sub-mode.
Press the [–/NO] or [+/YES] button to set a
selected parameter.
Sub-mode
F7.1:
(CLP-370/340)/F7.1: (CLP-S308/S306, CLP-330)
MIDI Transmit Channel Selection
In any MIDI control setup, the MIDI channels of the
transmitting and receiving equipment must be matched
for proper data transfer.
This parameter enables you to specify the channel on
which the Clavinova transmits MIDI data.
Setting range: 1 – 16, OFF (not transmitted)
Normal setting: 1
F6.
(CLP-370/340)
/ F5.
(CLP-S308/S306, CLP-330)
Metronome Volume
NOTE
SHORTCUT:
You can jump directly to the metronome functions (CLP-370/
340)/ (CLP-S308/S306, CLP-330) by pressing the [TEMPO/
FUNCTION] button while holding the METRONOME [ON/OFF] button.
To exit the Function mode, you still need to press the [TEMPO/
FUNCTION] button so that the TEMPO indicator lights up.
F7.
(CLP-370/340)
/ F6.
(CLP-S308/S306, CLP-330)
MIDI Functions
All MIDI settings described below will affect the MIDI signal
in and out of the USB [TO HOST] connector.
NOTE
In Dual mode, Voice 1 data is transmitted on its specified channel.
In Split mode (CLP-370/340), right voice data is transmitted on its
specified channel. In Dual mode, Voice 2 data is transmitted on the
next greater channel number relative to the specified channel. In
Split mode (CLP-370/340), left voice data is transmitted on the next
greater channel number relative to the specified channel. In either
mode, no data is transmitted if the transmit channel is set to “OFF.”
NOTE
Song data is not transmitted via the MIDI connections. However,
channels 3 – 16 of Disklavier Piano Soft songs, and non-protected
External songs will be transmitted via the MIDI connections depend-
ing on the Song Channel Selection setting (page 66).