Musical Instrument Owner's Manual

CLP-S308/S306: Keyboard Stand Assembly
CLP-370/340/330, CLP-S308/S306 Owner’s Manual
ENGLISH
88
1. Attach D to E and F.
1-1 Attach D to E and F by using four long screws
(6 x 20 mm).
1-2 Secure D from the rear using two long screws
(6 x 20 mm).
1-3 Remove the twist tie from the folded pedal cord.
Do not remove the twist tie that is located next to
the hole.
2. Attach B.
2-1 Insert B between E and F as shown in the illustration.
2-2 Align and attach B to the front side of D, E and F.
2-3 Temporarily secure B by finger-tighening four
long screws (6 x 20mm).
* Insert four screws into the larger holes (all four
holes) on the brackets.
2-4 Secure B using a thin screw (4 x 14 mm).
* Insert the screw into the smaller hole on the
bracket.
3. Mount A.
3-1 Place your hands at least 15 cm from either end
of A to mount it.
3-2 Position A so that the stopper-wood on the rear
side of the bottom of A will be located behind the
front panel, then slide A slowly toward the rear.
CAUTION
Be extra careful not to drop or let your fingers be pinched by the
main unit.
CAUTION
Do not hold the keyboard in any position other than the posi-
tion shown in the illustration.
4. Secure A.
4-1 Secure A from the rear using two short screws
(6 x 16 mm).
4-2 Secure A from the rear using two thin screws
(4 x 14 mm).
4-3 Secure A from the front using four short screws
(6 x 16mm).
4-4 Firmly tighten the screws you temporarily
fastened on B in steps 2-3 above.
1-1
1-2
1-3
E
D
F
2-2
2-1
F
E
B
D
2-3
2-4
A
3-1
3-2
15cm
or
further in
15cm
or
further in
4-1
4-2
4-3
A
4-4