Musical Instrument Owner's Manual

Installing the Optional Floppy Disk Drive (CLP-370/340)
CLP-370/340/330, CLP-S308/S306 Owner’s Manual
ENGLISH
91
Installing the Optional Floppy Disk Drive
(CLP-370/340)
The optional UD-FD01 floppy disk drive can be installed to the bottom of the instrument by using
the included floppy disk drive case and screws.
For the CLP-330 and CLP-S308/S306: The disk drive can be used with the instrument but cannot be
attached as described here. When using the floppy disk drive with these models, simply put the
drive on the top panel. Make sure to remove the connected disk cable before you close the key
cover.
1. Remove the three backing papers from
the adhesive tape in the case, and fit the
floppy disk drive into the case.
2. Fold the USB cable inside the case as
shown.
3. Attach the drive and case assembly to the
left underside of the instrument, using the
included four screws (4mm x 10mm).
4. Connect the USB cable to the USB [TO
DEVICE] terminal.
Have a Phillips-head (+) screwdriver ready.
Insert the drive to the case, with the side having
the rubber stoppers facing the case.
Dual-sided adhesive tape