Owner`s manual

Keyboard Stand Assembly

CLP-320 Owner’s Manual

ENGLISH

Keyboard Stand Assembly

CAUTION

• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-

dance with the sequence given below.

• Assembly should be carried out by at least two persons.

• Assemble the stand on the ﬂat ﬂoor surface.

• Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of

incorrect screws can cause damage or malfunction of the product.

• Be sure to tighten up all screws upon completing assembly of each unit.

•To disassemble, reverse the assembly sequence given below.

Remove all parts from the package and make sure you

have all of the items.

1. Attach (ﬁnger-tighten) C to D

and E.

1-1 Untie and straighten out the bundled pedal

cord. Don’t discard the vinyl tie. You will

need it later in step 6.

1-2 Align D and E with each end of C.

1-3 Attach D and E to C by ﬁnger-tightening the

long screws 1 (6 × 20mm).

Have a Phillips-head (+) screwdriver of the

appropriate size ready.

Bundled pedal cord

inside

AC Power cord

Assembly Parts

20 mm long screws

6 × 16 mm short screws ×4

4 × 12 mm thin screws ×2

4 × 20 mm tapping screws

Cord holders × 2

Headphone hanger set

4 × 10 mm thin screws ×2 5 Headphone hanger

1-2

1-1

1-3