User Manual

NUAGE Firmware Update Guide 10
■ Updating the Dante firmware
Described below are the procedures to update the Dante module firmware integrated in the Nuage I/O unit.
When updating Nuage I/O and Dante firmware needs to be updated, execute the following procedures.
・For details of the Dante Firmware Update Manager, refer to the “AUD-MAN-Firmware Update Manager" file stored in the compressed
file folder.
1. Connect the Dante [PRIMARY] connector on the rear panel of the Nuage I/O unit to the Ethernet connector on the
computer using an Ethernet cable.
Be sure to directly connect the computer and the Nuage I/O unit, and do not connect any other Dante device to the
computer.
2. Start up the Dante Firmware Update Manager as follows.
Windows
Select "All programs" or "All apps"  "Audinate"  "Dante Firmware Update Manager" 
"Dante Firmware Update Manager."
Mac
Double-click "Applications"  "Dante Firmware Update Manager."
・Check in the title bar that the version number is 1.3.2 or higher.
・The "User Account Control" dialog box may appear. Click [Continue] or [Yes].
3. Click [Update Dante Firmware].
4. Click [Browse] and select “FWUpdate_Nio500_vxxx_swyyy.dnt." Then click [Open].
xxx and yyy represent the firmware version number.
・The Dante firmware does not operate normally if its path contains any multi-byte character (including Japanese characters). If
you use a directory name containing any multi-byte character in your computer, store the firmware update files in a
directory that consists only of ASCII characters (e.g. C:\temp).
・Be sure to ensure compatibility of the update files with Nuage I/O. If update files other than Nuage I/O are applied, the
device will become inoperable. In general, do not check the [Override Device Matching] option. If this option is left
unchecked, only devices that support the file can be selected, ensuring that updating the device with invalid or wrong
files is prevented.