User Manual

Added functions in NUAGE V2.1 55
Support for remote control of RMP-D8 (Nuage Fader)
It is now possible to operate the HA gain on Rupert Neve Designs RMP-D8 with a [Multi function knob].
Press [PRE] in the SECTION CONTROL section, and then press [Sub parameter 2] to operate the “HA GAIN” and “HA GC”
on the input channel where the RMP-D8 is connected.
Press [e] (edit) on the input channel where the RMP-D8 is connected, and then press [PRE] in the SECTION CONTROL
section to control the “HA GAIN” “HA GC,” “HA HPF” (On/Off only), and “HA +48V” on the channel where [e] was pressed.
If an input bus with multiple channels (such as stereo or surround channels) has been assigned, the parameters for the bus
channel appearing first in Nuendo’s “Audio Connections” (“Left” for a stereo channel) are shown in the label area.
The channel values that have been set with Nuage Fader are applied to all channels on that bus. (The settings for “Left”
(channel) are also applied to “Right” (channel), even though that channel does not appear on the screen.) If the values for
all channels on a bus are not the same, an asterisk (*) is added after the parameter. (“HA GAIN*”, for example)
RMP-D8 Settings
In the Nuendo menu, select “Devices”  “NUAGE HA Remote Setup” to open the settings screen and configure the Dante
Accelerator you will use.
NOTE
This feature cannot be used in Mac OS X 10.11, even though Mac OS X 10.11 is otherwise supported.
Operation Function
"HA GAIN" Adjusts the gain.
"HA GC" Turns the gain compensation on and off.
"HA HPF" Turns the High Pass Filter on and off. The filter frequency cannot be operated.
"HA +48V" Turns +48 V phantom power on and off. To turn on phantom power, press and hold down [Multi function button A].