User Manual

Added functions in NUAGE V1.6 88
Added More Parameters to
Channel Strip Section
(Nuage Fader)
You can now adjust HC SLOPE, LC SLOPE, GAIN,
 (PHASE), HA HPF, and HA +48V in the channel strip.
HA GAIN and HA GC, which were previously assigned to
[Sub parameter 2], have been moved to [Sub parameter
4].
Operation
1. Press [PRE] in the SECTION CONTROL section.
2. Press one of the parameters in [Sub parameter 2] to
[Sub parameter 5].
The parameters below are displayed in the label area.
3. Adjust the parameter using the corresponding
[Multi function knob] or [Multi function button].
Sub parameter 2
Sub parameter 3
Sub parameter 4
Sub parameter 5
Added Support for Switching
Parameters in Channel Setting
Mode (Nuage Fader)
You can now switch sub-parameters in the Channel
Setting mode to make adjustments to parameters.
NOTE
Only the following two types of “Dynamics” are currently
supported:
• DeEsser (Cubase Pro 8 and later)
• Envelope Shaper
Operation
With either DeEsser or Envelope Shaper selected in
“Dynamics” in the channel displayed in Channel Setting
mode, do the following:
1. Press [DYN] in the SECTION CONTROL section.
2. Press [Sub parameter 2].
The parameter display in the label area is switched.
3. Adjust the parameter using the corresponding
[Multi function knob] or [Multi function button].
Added Key Function
(Shortcut) for Dividing Events
into Selected Ranges (Nuage
Master)
You can now use key function (shortcut) in Nuage Master
to divide events into selected ranges.
Operation
1. In the Nuendo Project window, use the range
selection tool to select the range for dividing a
track.
2. Press and hold [SHIFT] in the MODIFIER section
while holding down [SPLIT] in the JOG WHEEL
section.
The event is divided into the selected ranges.
HC SLOPE, LC SLOPE
GAIN,  (PHASE)
HA GAIN, HA GC
(for Rio3224-D/Rio1608-D remote control)
HA GAIN, HA TRIM
(for AD8HR remote control)
HA HPF, HA +48V
(for HA remote control)