User Manual

Added functions in NUAGE V1.5 97
Added support for new
Nuendo 6.5 plug-in (Nuage
Master, Nuage Fader)
You can now select [DYN] in the SECTION CONTROL
section to control the parameters of the new Nuendo 6.5
plug-in (Magneto II).
You can also now control the Noise Gate parameters.
(The screen shown below is from Nuage Master. )
Added support for additional
Nuendo 6.5 ADR functions
(Nuage Master)
Support has been added for the improved ADR functions
in Nuendo 6.5.
TRANSPORT – ADR Sub Page
1 Free Run
Turns Free Run mode on and off.
For ADR on the User Assignable tab, U8 is fixed to Free
Run mode.
In addition, the following functions have been added to
the initial settings for the UserAssign button.
2 U3: Mute Guide CR (Control Room Guide
Track On/Off)
3 U7: ADR Status (ADR Status Indicator On/
Off)
TRANSPORT Section
In ADR mode, the functions of the buttons in the
TRANSPORT section change.
[PREROLL]
Turns Pre Roll on and off in Free Run mode.
This button does not function in any mode other than Free
Run.
[POSTROLL]
Turns Free Run mode on and off.
Added direct monitoring
settings (Nuage I/O)
You can now select an output for direct monitoring in
NUAGE I/O Setup.
To open the NUAGE I/O Setup screen, in the Nuendo
menu select “Devices” “NUAGE I/O Setup”.
NOTE
A maximum of 16 channels can be selected for direct
monitoring. You cannot select a bus that has more than 16
channels already assigned.
Only one monitor bus for the Control Room in Nuendo can be
selected for direct monitoring.
NUAGE I/O Setup –
Direct Monitoring Screen
1 Dante Interface
Specifies the Dante Accelerator used by the DAW.
2 Add Channel
Adds an output bus for direct monitoring.
2 13
1 3 42
6
7
5