manual

112 CLP-280/270 Owner’s Manual
Appendix
CLP-280/270: Keyboard Stand Assembly
5. Connect the speaker cord.
5-1 Remove the twist tie attaching the speaker
cord.
5-2 Insert the speaker cord plug into the connector
so that the tab extends toward the front when
viewed from the rear.
6. Connect the pedal cord.
6-1 Insert the pedal cord plug into the [PEDAL]
connector.
6-2 Attach the cord holders to the instrument, then
clip the cord into the holders. At this time, be
careful that the pedal cord isn’t loose between
the plug and cord holder.
6-3 Use a twist tie to bundle the pedal cord.
7. Attach C.
7-1 Place on D, the stopper-wood at the bottom
edges of C, then secure the top.
7-2 Secure upper right and left of C using two 4 x
14mm thin screws.
7-3 Secure upper center and lower of C using five
4 x 20mm tapping screws.
8. Connect the power cord.
Insert the AC power cord plug into the [AC
INLET].
6-1
6-2
6-3
7-1
7-2
7-3
240
127
110
220
For models that feature
a voltage selector:
Set the voltage selector to an
appropriate voltage.