Operation Manual

62
Detailed Settings
Detailed settings for Voices — [VOICE SETTING]
You can specify the position in the stereo image from
which you hear the sound.
Setting range:
L64 (hard left) – C (center) – R63 (hard right)
Default setting:
Differs depending on the Voice.
The pitch of the two sounds selected in the Dual mode
can be “skewed” slightly away from each other.
Setting range:
-20 – +20 (Positive (+) settings will raise the pitch of Voice 1 and
lower the pitch of Voice 2. Negative (–) settings will do the
opposite.)
Default setting:
Differs depending on the Voice.
The Reverb Type selection is applied to all the Voice parts
commonly or the instrument entirely.
Setting range:
• Room
Simulates reverberation in a room.
• Hall1
Simulates reverberation in a concert hall.
• Hall2
Reverberation is slightly longer than that of “Hall1.”
•Stage
Reverberation suitable for a solo instrument sound.
•Plate
Reverberation simulating that created by vibration of a metal
plate.
Default setting:
Differs depending on the Voice or Voice combination.
NOTE
The reverb effect is not applied if the ReverbSend parameter is set
to “0.”
Setting range:
0 – 127
Default setting:
Differs depending on the Voice.
The Chorus Type selection is applied to all the Voice parts
commonly or the instrument entirely.
Setting range:
•Chorus
Adds a rich, spacious sound.
•Celeste
Adds swell and a spacious sound.
• Flanger
Adds swell effects similar to the sound of an ascending or
descending jet plane.
Default setting:
Differs depending on the Voice or Voice combination.
Setting the position of right and left
channels*
Pan
Make fine adjustments to the pitch
(only in Dual mode)
Detune
Selecting the reverb type
ReverbType
Pan Set?
_
>
Main(GrndPno ) C
Store the setting.
Set the value.Select a Voice part.
Detune Set?
_
>
MainxLayer + 3
Store the setting.
Set the value.Select a Voice part.
ReverbType Set?
_
>
Hall1
Store the setting.
Set the value.
Setting the reverb depth*
ReverbSend
Selecting the chorus type
ChorusType
ReverbSend Set?
_
>
Main(GrndPno ) 10
Store the setting.
Set the value.Select a Voice part.
ChorusType Set?
_
>
Chorus
Store the setting.
Set the value.