Operation Manual

82
Appendix
Assembling the Clavinova
Assembling the Clavinova
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the
sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Remove all parts from the package and make sure you have all of the items.
Have a Philips-head (+) screwdriver of the appropriate size ready.
A
B
C
D
F
E
AC IN
Connector
panel
The pedals are covered with vinyl covers when
shipped from the factory. For optimum use of the
GP Responsive Damper Pedal, we recommend
that you remove the cover from the damper pedal.
Pedal cord
6 x 20 mm long screws x 4
6 x 16 mm short screws x 6
4 x 14 mm thin screws x 9
4 x 10 mm thin screws x 2
Cord holders x 2
Power cord
Headphone hanger
Foamed styrol pads
Take out the styrofoam pads, and place A on top of the pads.
Position the styrofoam pads so that they do not interfere with
the connector panel at the bottom of A, AC IN, or the fittings on
the center of the rear panel.
4 x 20 mm
tapping screws x 4