Operation Manual
70
CLP-585/575/545/535/565GP Owner’s Manual
Connections
You can connect a USB flash memory or a USB wireless LAN adaptor (sold separately) to the USB [TO
DEVICE] terminal. You can save data you’ve created on the instrument to the USB flash memory (pages 61,
94), or you can connect the instrument to a smart device such as an iPad via wireless LAN (page72).
Connecting USB Devices (USB [TO DEVICE] Terminal)
Precautions when using the USB
[TO DEVICE] terminal
This instrument features a built-in USB [TO
DEVICE] terminal. When connecting a USB device
to the terminal, be sure to handle the USB device with
care. Follow the important precautions below.
NOTE
For more information about the handling of USB devices, refer
to the owner’s manual of the USB device.
Compatible USB devices
• USB flash memory
•USB hub
• USB wireless adaptor (sold separately) page121
Other USB devices such as a computer keyboard or
mouse cannot be used.
Although USB devices 1.1 to 3.0 can be used on this
instrument, the amount of time for saving to or
loading from the USB device may differ depending
on the type of data or the status of the instrument.
The instrument does not necessarily support all
commercially available USB devices. Yamaha cannot
guarantee operation of USB devices that you
purchase. Before purchasing a USB device for use
with this instrument, please visit the following web
page:
http://download.yamaha.com/
NOTE
The rating of the USB [TO DEVICE] terminal is a maximum of
5V/500mA. Do not connect USB devices having a rating
above this, since this can cause damage to the instrument
itself.
Connecting USB device
When connecting a USB device
to the USB [TO DEVICE]
terminal, make sure that the
connector on the device is
appropriate and that it is
connected in the proper
direction.
NOTICE
• Avoid connecting or disconnecting the USB device while
executing playback/recording and file management
operations (such as Save, Copy, Delete and Format), or
when accessing the USB device. Failure to observe this may
result in “freezing” of the operation of the instrument or
corruption of the USB device and the data.
• When connecting then disconnecting the USB device (and
vice versa), make sure to wait a few seconds between the
two operations.
NOTE
• If you intend to connect two or three devices at the same
time to a terminal, you should use a bus-powered USB hub.
Only one USB hub can be used. If an error message
appears while using the USB hub, disconnect the hub from
the instrument, then turn on the power of the instrument and
re-connect the USB hub.
• When connecting a USB cable, make sure that the length is
less than 3 meters.
Using USB Flash Memories
By connecting the instrument to a USB flash
memory, you can save data you’ve created to the
connected device, as well as read data from the
connected USB flash memory.
Maximum number of USB flash memory
allowed
Only one USB flash memory can be connected to the
USB [TO DEVICE] terminal. (The number of USB
flash memories that can be used simultaneously with
musical instruments even when a USB hub is used is
only one.)
Formatting USB flash memory
You should format the USB flash memory only with
this instrument (page92). USB flash memory
formatted on another device may not operate
properly.
NOTICE
The format operation overwrites any previously existing data.
Make sure that the USB flash memory you are formatting does
not contain important data.
To protect your data (write-protect)
To prevent important data from being inadvertently
erased, apply the write-protect provided with each
USB flash memory. If you are saving data to the USB
flash memory, make sure to disable write-protect.
Turning off the instrument
When turning off the instrument, make sure that the
instrument is NOT accessing the USB flash memory
by playback/recording or file management (such as
during Save, Copy, Delete and Format operations).
Failure to do so may corrupt the USB flash memory
and the data.