User Manual
7
PSS-F30 Owner’s Manual
This instrument requires four “AA” size, Alkaline
(LR6)/Manganese (R6) batteries, or rechargeable
nickel-metal hydride batteries (rechargeable Ni-MH
batteries). The Alkaline batteries or rechargeable
Ni-MH batteries are recommended for this instru-
ment, since other types may result in poorer battery
performance.
1 Make sure that the power of the instrument is
off.
2 Open the battery compartment cover located on
the instrument’s bottom panel.
3 Insert the four new batteries, being careful to fol-
low the polarity markings on the inside of the
compartment.
4 Replace the compartment cover, making sure
that it locks firmly in place.
Press the [ ] (Standby/On) switch to turn the
power on; the display lights.
Hold down the [ ] (Standby/On) switch for about
one second to set the power of the instrument to
standby.
Use the MASTER VOLUME buttons.
Volume range: 00–15 (default 13).
NOTE
2 Using Batteries
• See the “Battery” section in the Precautions (page 4).
• Make sure to set the Battery Type correctly (page 10).
Failure to set the battery type may shorten the amount of
the battery life.
• Connecting or disconnecting the USB cable with batteries
installed may turn the power off, resulting in loss of data.
WARNING
NOTICE
Turning the Power On/Standby
Adjust the Master Volume
This instrument has a Volume Limit function to prevent
the Master Volume from accidentally being set to too
high a level. For the operation, see “Volume Limit” on
page 10.
• Volume setting will be reset to the default value 13 when “Ini-
tialization” (page 11) is done.
0.0.1
0.0.1
Increases
Decreases
05