User Manual

Message List
103
CLP-585/575/545/535/565GP Owner’s Manual
No device A USB flash memory was not connected to the instrument when you attempted to perform a device-related
operation. Connect the device, and try again.
No response
from USB device
The instrument cannot communicate with the connected USB device. Redo the connection (page70). If
you still see this message, the USB device may be damaged.
Notice:
Protected Song
This message appears when you attempt to handle the Protected Song. For information on the limitation of
file operations, see page61.
Please wait The instrument is processing the data. Wait until the message disappears, then go on to the next step.
Protected device This message appears when you attempt a file operation (page61), record your performance or save the
data on a read-only USB flash memory. Cancel the read-only setting, if possible, and try again. If you still
see this message, the USB flash memory is internally protected (such as commercially available music
data). You cannot make the file operation or record your performance to such a device.
Protected Song You attempted a file operation to a Protected Song or read-only file. Data of those types have handling
limitations (page61), and also cannot be used for editing (page57). Use a read-only file after cancelling
the read-only setting.
Remaining space
on drive is low
Since the remaining space on the “User”/USB flash memory is low, delete any unnecessary files (page63)
before recording.
Same file name exists This message appears to prompt you to confirm if overwriting or not when executing a Copy/Move/
MIDItoAudio operation.
Song error This message appears, if a problem is found with the Song data when you select a Song or while the Song
is playing. In this case, reselect the Song, and try again to play back. If the message still appears, the Song
data may have been damaged.
Song too large The size of Song data (MIDI/Audio) exceeds the limitation. The following causes can be considered.
• The Song size you attempt to play back exceeds the limitation. The limitation for playback is approx.
500KB (MIDI), 80 minutes (Audio).
• The Song size exceeds the limitation during recording. The limitation for recording is approx. 500KB
(MIDI), 80 minutes (Audio). The Audio recording will end automatically and the recorded data before the
end is saved; however, the MIDI Song will be lost.
• The Song size exceeds the limitation during converting a MIDI Song to an Audio Song. The limitation is 80
minutes (Audio).
System limit This message appears when the number of files exceeds the system limit. The maximum number of files
which can be saved in a folder is 250. Try again after deleting/moving the unnecessary file(s).
Unformatted device This message appears when you attempt to use an unformatted USB flash memory. Format it (page92),
and try again.
Unsupported device This message appears when an unsupported USB flash memory is connected. Use a device whose
compatibility has been confirmed by Yamaha (page70).
USB device
overcurrent error
Communication with the USB device has been cut off because of an abnormal power surge to the device.
Disconnect the USB device from the USB [TO DEVICE] terminal and turn the [P] (Standby/On) switch of
the instrument standby and on again.
USB hub
hierarchical error
The USB hub is connected in two layers. USB hub use is limited to one layer.
USB power consumption
exceeded
A
bus-powered USB hub is usually recommended. When this message appears, however, use a self-powered
USB hub (with its own power source) and turn the power to on, or use a device whose compatibility
has been
confirmed by Yamaha (page70).
Wrong device The file operation cannot be made to the connected USB flash memory. The following causes can be
considered.
• The USB flash memory in not formatted. Format it (page92), and try again.
• The number of files exceeds the system limit. The maximum number of files and folders which can be
saved in a folder is 250. Try again after deleting/moving the unnecessary file(s).
Wrong name The Song name is not appropriate. This message appears during the “Renaming files” (page66) operation
because of the following causes. Rename the Song correctly.
• No character has been input.
• You used a period or space at the beginning/ending of a Song name.
Message Meaning