User Manual

Assembling the Clavinova
121
CLP-785, CLP-775, CLP-745, CLP-735, CLP-795GP, CLP-765GP Owner’s Manual
2-2. Secure the bottom end of B using four
tapping screws (4 × 20 mm).
2-3. Securely tighten the screws on the top of B
that were attached in step 2-1.
3. Mount A.
Be sure to place your hands at least 15 cm away from
either end of the main unit when positioning it.
CAUTION
• Be extra careful not to drop the main unit or let your fingers
be pinched by it.
• Do not hold the main unit in any position other than the
position specified above.
4. Secure A.
4-1. Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally (as seen from the front).
4-2. Secure A by tightening six thick screws (6 ×
20 mm) from the front.
5. Connect the pedal cord and AC
adaptor.
5-1. Insert the plug of the pedal cord into the
pedal connector.
5-2. Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
5-3. Use a vinyl tie to take up any slack in the
pedal cord.
5-4. Connect one end of the power cord to the
AC adaptor.
5-5. Insert the DC plug of the AC adaptor into
the DC IN jack.
AA
Align the screw holes.
At least 15 cm
AA
4-2
4-1
AA
Insert the pedal cord securely
until the metal part of the
cord plug disappears from
view. Otherwise, the pedal
may not function properly.
5-15-1
5-3
5-5
5-2
PEDAL