User Manual

System Menu
100
CLP-785, CLP-775, CLP-745, CLP-735, CLP-795GP, CLP-765GP Owner’s Manual
MIDI Initial Setup Cancel Transmits the current panel settings such as Voice
selection to a connected MIDI device or computer.
Before you start recording your performance to a
connected MIDI device or computer, execute this
operation to record the current panel settings at the
beginning of your performance data. It causes that the
same panel settings are called up when the recorded
performance is played back.
Operation:
Move the highlight to “Execute,” then press the [>] button
to transmit the panel settings as MIDI messages.
––
Execute
Backup Backup Setting – For instructions about these functions, refer to pages 104
– 105.
––
Backup –
Restore –
Factory Reset –
Utility USB Format Cancel This lets you format or initialize the USB flash drive
connected to the USB [TO DEVICE] terminal.
NOTICE
Executing the Format operation will delete all data saved in the
USB flash drive. Save important data to a computer or another
storage device.
NOTE
When connecting the USB flash drive to the USB
[TO DEVICE] terminal, a message prompting you to execute
the Format operation may appear. If such a case occurs,
execute the Format operation.
Operation
Move the highlight to “Execute,” then press the [>] button
to start the Format operation. After Formatting is
completed, a message appears then the instrument
returns to the Utility display after a while.
NOTICE
Never turn off the power or disconnect the USB flash drive
while “Executing” is shown in the display.
––
Execute
USB Properties – Shows the amount of free space and entire memory in
the USB flash drive connected to the USB [TO DEVICE]
terminal.
––
USB Autoload – When this is set to “On,” the Song saved in the root
directory can be selected (shown on the display)
automatically as soon as the USB flash drive is
connected to the USB [TO DEVICE] terminal.
Off On, Off
Speaker (Setting
display)
Lets you switch the speaker on/off.
• Normal: The speaker will sound only if headphones are
not connected.
• On: The speaker will always sound.
• Off: The speaker will not sound.
NOTE
When this setting is on, “Binaural” (page 99) will always be
disabled.
Normal Normal, On, Off
To call up the desired parameter:
Press the [FUNCTION] button several times to select “System” menu, then use
the [u]/[d]/[<]/[>] buttons to select the desired parameter.
[>]
[<]
[>]
[<]
[>]
[<]
Description Default setting Setting range
785 775
745 735
795GP
765GP
Amount of
free space
Amount of
entire memory