User Manual

Assembling the Clavinova
120
CLP-785, CLP-775, CLP-745, CLP-735, CLP-795GP, CLP-765GP Owner’s Manual
Remove all parts from the package and make sure
you have all of the items.
The power cord and AC adaptor may not be included, or may look different
from the illustration above, depending on your particular area. Please check
with your Yamaha dealer.
1. Attach C to D and E.
1-1. Untie and straighten out the bundled pedal
cord. Do not discard the vinyl tie. You will
need it later in step 5.
1-2. Insert the protrusions into the holes on the
brackets, then attach D and E to C by
tightening the four thick screws (6 × 20 mm).
2. Attach B.
Depending on the model of digital piano you
purchased, the surface color of one side of B may
be different from the other side. If so, position B
so that the side similar in color to D and E faces
the player.
2-1. Align the screw holes on the upper side of B
with the bracket holes on D and E, then attach
the upper corners of B to D and E by finger-
tightening two thin screws (4 × 12 mm).
CLP-775 Assembly
A
DE
B
C
Foamed styrol pads
Remove foamed styrol pads from the package, position them on the
floor, then place A on top of them. Position the pads so that they will
not block the speaker box on the bottom of A.
Bundled pedal
cord inside
The pedals are covered with vinyl covers
when shipped from the factory. Before
starting the assembly, please make sure to
remove the cover from the damper pedal.
6 × 20 mm thick screws × 10
4 × 12 mm thin screws × 2
4 × 20 mm tapping screws × 4
Power cord
Cord holders × 2
4 × 10 mm thin screws × 2
Headphone hanger
AC adaptor
1-2
1-1
D
D
E
E
C
C
1-2
1-2
2-1, 2-3
2-2
D
B
E