Operation Manual
27
CLP-950/930
The Function Mode
The [FUNCTION] button provides access to a range of functions that give the
Clavinova extraordinary versatility. The functions are categorized in groups as
follows:
CLP-930 CLP-950
F1 F1 Tuning ............................................................. 28
F2 F2 Scale ............................................................... 28
F3 F3 Dual Mode Functions .................................... 29
– F4 Split Mode Functions .................................... 30
F4 – Left Pedal Mode ............................................. 31
– F5 Pedal Functions ............................................. 32
F5 F6 Metronome Volume ........................................ 32
F6 F7 Preset Song Part Cancel Volume.................. 32
F7 F8 MIDI Functions ............................................... 33
F8 F9 Backup Functions.......................................... 36
To Select a Function … ...........................................................................
ZPress the [FUNCTION] button so that its indicator lights.
NOTE
• Functions cannot be selected during demo/preset song playback or when
the user song recorder is in operation.
XUse the [TEMPO/FUNCTION t, s] buttons to select the desired
function: F1 through F8 on the CLP-930; F1 through F9 on the
CLP-950.
CIn the case of the Scale (F2), Dual Mode (F3), Split Mode (F4:
CLP-950), Pedal Functions (F5: CLP-950), MIDI (F7: CLP-930,
F8: CLP-950), and Backup (F8: CLP-930, F9: CLP-950) functions,
you will have to press the [+/YES] button once to enter the respec-
tive sub-mode after the function has been selected, and then use the
[TEMPO/FUNCTION t, s] buttons again to select the desired
sub-function.
NOTE
• The Dual or Split (CLP-950) mode must be engaged before the F3 and
F4 functions can be selected, respectively. If the corresponding mode is
not engaged, “
F3.-
” or “
F4.-
” will appear on the display and the corre-
sponding sub-mode will not be available.
• The Dual mode can be engaged while in the Function mode, but the
Function mode must be exited before the Split mode (CLP-950) can be
engaged.
VSet the function as required by using the [–/NO] and [+/YES]
buttons (see the individual function descriptions, below).
NOTE
• After selecting the function, the current setting will be displayed when the
[–/NO] or [+/YES] button is pressed for the first time.
BPress the [FUNCTION] button so that its indicator goes out to exit
from the function mode.
● Operation Example
(sub-mode)
Press [+/YES]
Use [TEMPO/
FUNCTION t, s]
Use [–/NO], [+/YES]
Press [–/NO] or [+/YES]
once
ON
FUNCTION
START/
STOP
TEMPO/FUNCTION
METRONOME
ON
FUNCTION
START/
STOP
TEMPO/FUNCTION
METRONOME