Operation Manual

CLP-970 27
MIDI Data Format
2.2.1 XG bulk dump
This message sets XG-related parameters. Unlike parameter change messages, a single
message can modify multiple parameters. The message format is as follows.
11110000 F0H Exclusive status
01000011 43H YAMAHA ID
0000nnnn 0NH N:Device Number
01001100 4CH Model ID
0sssssss SSH ByteCountMSB
0ttttttt TTH ByteCountLSB
0ggggggg GGH Address High
0mmmmmmm MMH Address Mid
0lllllll LLH Address Low
0vvvvvvv VVH Data
: :
0kkkkkkk KKH Check-sum
11110111 F7H End of Exclusive
Address and Byte Count are given in tables 1-n. Byte Count is indicated by the total
size of the Data in tables 1-n.
Bulk dump and dump request messages are received when the beginning of the block
is specified as the 'Address'.
'Block' indicates the unit of the data string that is indicated in tables 1-n as 'Total size'.
Check sum is the value that produces a lower 7 bits of 0 when the Start Address, Byte
Count, Data, and the Check-sum itself are added.
2.2.1.1 XG System bulk dump
This message sets the XG SYSTEM block (refer to tables <1 -1>, <1 - 2>).
2.2.1.2 Multi Effect1 bulk dump
This message sets the MULTI EFFECT1 block (refer to tables <1 - 1>,
<1 - 3>).
2.2.1.3 Multi Part bulk dump
This message sets the MULTI PART block (refer to tables <1 - 1>, <1 - 4>).
2.2.1.4 Drums Setup bulk dump
This message sets the DRUMS SETUP block (refer to tables <1 - 1>, <1 - 5>).
3. Realtime messages
3.1 Active sensing
a) Transmission
not transmitted.
b) Receive
Once FE has been received, failure to receive any MIDI message for an interval
longer than approximately 300 msec will cause processing to be performed as if
ALL SOUND OFF, ALL NOTE OFF, and RESET ALL CONTROLLERS mes-
sages were received, and the unit will reset to a condition in which FE was never
received.
< Table 1-1 >
< Table 1-2 >
MIDI Parameter Change table ( XG SYSTEM )
Address Size Data Parameter Description Default value
(H) (H) (H) (H)
00 00 00 4 00 - 0F MASTER TUNE -102.4...0...+102.3[cent] 00 04 00 00
01 00 - 0F 1st bit3-0→bit15-12
02 00 - 0F 2nd bit3-0→bit11-8
03 00 - 0F 3rd bit3-0→bit7-4
4th bit3-0→bit3-0
04 1 00 - 7F MASTER VOLUME 0...127 7F
05 1 not used
06 1 28 - 58 TRANSPOSE -24...0...+24[semitones] 40
7D 1 N DRUM SETUP RESET N: Drum setup number(0,1) --
7E 1 00 XG SYSTEM ON 00=XG system ON (receive only) --
7F 1 00 ALL PARAMETER RESET 00=ON (receive only) --
TOTAL SIZE 07
Parameter Base Address
MODEL ID = 4C
Parameter Description
Address
(H) (M) (L)
XG SYSTEM 00 00 00 System
00 00 7D Drum setup Reset
00 00 7E XG System On
00 00 7F All Parameter Reset
EFFECT 1 02 01 00 Effect1(Reverb,Chorus,Variation)
MULTI PART 08
:
08
00
:
0F
00
:
00
Multi Part 1
:
Multi Part 16
DRUM 30
31
0D
0D
00
00
Drum Setup 1
Drum Setup 2
Address Parameter
3n 0D 00 note number 13
3n
3n
0E
:
5B
00
00
note number 14
:
note number 91