Owner`s manual

CLP-S308/S306: Keyboard Stand Assembly
CLP-370/340/330, CLP-S308/S306 Owner’s Manual
ENGLISH
88
1. Attach D to E and F.
1-1 Attach D to E and F by using four long screws
(6 x 20 mm).
1-2 Secure D from the rear using two long screws
(6 x 20 mm).
1-3 Remove the twist tie from the folded pedal cord.
Do not remove the twist tie that is located next to
the hole.
2. Temporarily mount B.
2-1 Insert B between E and F as shown in the illustration.
2-2 Align and attach B to the front side of D, E and F.
2-3 Temporarily secure B by finger-tightening four
long screws (6 x 20mm).
* Insert four screws into the larger holes (all four
holes) on the brackets.
2-4 Secure B using a thin screw (4 x 14 mm).
* Insert the screw into the smaller hole on the
bracket.
3. Mount A.
3-1 Place your hands at least 15 cm from either end
of A to mount it.
3-2 Position A so that the stopper-wood on the rear
side of the bottom of A will be located behind the
front panel, then slide A slowly toward the rear
while lightly pushing E and F toward the center.
* Be sure to slide the guide pins 1 on each side of
A into the guide slots 2 on E and F respectively.
CAUTION
Be extra careful to avoid pinching your fingers or dropping A.
CAUTION
Do not hold the keyboard in any position other than the posi-
tion shown in the illustration.
4. Secure A.
4-1 Secure A from the rear using two short screws
(6 x 16 mm).
4-2 Secure A from the rear using two thin screws
(4 x 14 mm).
4-3 Secure A from the front using four short screws
(6 x 16mm).
4-4 Firmly tighten the screws you temporarily
fastened on B in steps 2-3 above.
1-1
1-2
1-3
E
D
F
2-2
2-1
F
E
B
D
2-3
2-4
15cm
15cm
A
2
1
1
2
F
E
3-1
3-2
or
further in
or
further in
4-1
4-2
4-3
A
4-4