User Manual

MG10XUF Owner’s Manual
11
Quick Start Guide
8. Make sure that the volume of a powered speaker or
amplifier is set to the minimum.
9. Turn on the power to the connected devices in the
following order: (microphone), (instru-
ment), (audio device)  [ / ] (this unit) 
(speakers).
NOTICE
Follow this order to prevent any loud, unexpected
noise from the speakers. Reverse the order when
turning the power off.
10.While playing your instrument or speaking into a
microphone, adjust the input signal with the [GAIN]
knob until it goes past the “0” () position on the
level meter only occasionally.
NOTE
If you connect a portable audio player, synthesizer, or other
equipment to a stereo input channel that has no [GAIN] knob,
adjust the output level on the connected device.
11. Turn on ( ) the [ON] switches for each channel
you are using.
12.Turn off ( ) all [PFL] switches.
13.Turn on ( ) the [ON] switch for the [STEREO]
master.
14.Raise the [STEREO] master fader to the “0” posi-
tion.
15.While playing your instrument or speaking into the
microphone, raise the volume of the powered
speaker or amplifier until the desired volume is
reached.
NOTE
If the sound is not heard or the sound is distorted, follow the
instructions on page 18.
16.Set the channel faders to create the desired initial
balance.
17. Adjust the overall volume of the [STEREO] master
fader.
This completes the STEP 2 instructions.
NOTE
The volume can be adjusted by using three functions; [PAD],
[GAIN], and channel fader. Once you set the [PAD] switch and the
[GAIN] knob, avoid adjusting those controls as much as possible.
Instead normally use the channel fader to adjust the volume. For
details about each function, see the “Controls and Functions” sec-
tion.
14, 17
[STEREO]
fader
12
[PFL] switch
11
[ON] switch
13
[ON] switch
16
Channel fader