User Manual

MG10XUF Owner’s Manual

Troubleshooting

STEP 2 Setting Switches and Controls

 Check the overall balance

Use the settings shown in the illustration to check the overall balance from speakers or headphones.

 To monitor the signal of each channel

You can use the level meter and headphones to check the pre-fader signal for each channel.

• [PFL] switches: Turn on ( ) for the channel(s) you want to check.

[GAIN] knobs

Turn until the [PEAK] indi-

cator begins to flash inter-

mittently.

Level meter

If the level meter [PEAK] indica-

tor flashes frequently, lower the

faders for each channel.

[PHANTOM +48V] switch

Turn this switch on (the indicator lit) when using a condenser microphone.

• To prevent an unwanted burst of noise from the speakers, turn off powered speak-

ers (or power amps) before turning on the [PHANTOM +48V] switch.

[PEAK]

indicators

[MONITOR/PHONES] knob

For adjusting the headphone

level and the MONITOR level.

[ON] switches

On (lit)

[PFL] switches

All off ( )

• When [PFL] switches are on, only the signals from those channels

are sent to the level meter and headphones. Therefore, you will be

unable to check the overall sound.

• If the [PFL] indicator below the level meter is flashing, one or more

[PFL] switches are on.

Channel faders

For adjusting the level for each

channel.

[STEREO] master fader

For adjusting the overall volume,

with “0” as the nominal level.