Owner`s manual

CP300 Owner’s Manual
11
Introduction
Before Using the CP300
1 Make sure that the instrument’s [POWER] switch on the rear panel is at the OFF
position.
2 Connect the supplied power cord to the [AC INLET] jack (page 22) on the
instrument’s rear panel.
3 Connect the other end of the power cord to an AC outlet. Make sure your CP300
meets the voltage requirement for the country or region in which it is being used.
Connect the included pedal (FC3) to the [1 SUSTAIN] jack.
An optional FC3/FC4/FC5 foot switch or FC7 foot controller can alternately be connected to this jack. Also
an optional FC3/FC4/FC5 foot switch or FC7 foot controller can be connected to the [4 AUX] jack, and can
be assigned to control a variety of parameters on the instrument (page 33).
Power Supply Connections
Using the Pedals
POWER
ON
OFF
POWER
OFF!!
AC INLET jack
Power cord (included)
AC INLET
ASSIGNABLE FOOT PEDAL
1
SUSTAIN
4
AUX
3
SOFT
2
SOSTENUTO
MIDI
IN
OUT
THRU
USB
OUTPUT OUTPUT INPUT
RL RL/MONO R L/MONO
ASSIGNABLE FOOT PEDAL
1
SUSTAIN
4
AUX
3
SOFT
2
SOSTENUTO
FC7
FC3/FC4/FC5