Owner`s manual

Detailed Settings for the Voices—Voice Edit
CP300 Owner’s Manual
58
Reference
Parameters
This allows you to shift the pitch of a note upward or
downward in octave steps, over a range of +/- two octaves.
Setting range: -2 – 0 – +2
-2 (two octaves lower), 0 (no pitch shift), +2 (two octaves higher)
This allows you to set the volume level for each Voice part.
Setting range: 0 – 127
This allows you to set the position of the sound in the
stereo field, left or right.
Setting range: L64 (hard left) – C (center) – R63 (hard right)
This allows you to finely tune the pitches of the two Voices
selected in Dual mode away from each other. Used
especially with similar sounding Voices, this creates a
warmer, richer sound.
Setting range: -20 – +20 (Positive (+) settings will raise the
pitch of the Main or Left Voice part’s sound and lower the pitch of
the Layer or Left Layer Voice part’s sound. Negative (-) settings
will do the opposite.)
This determines the types of Reverb effects used for the
Voices of the Main and Main x Layer parts. The Reverb
Type settings here are also used for the Voices of the Left
and Left x Left Layer parts, respectively. (These cannot be
set independently from the Main and Main x Layer Voices.)
Settings:
This allows you to control the depth of the reverb effect for
the Voice.
n The reverb effect is not applied if “Reverb Send” is set to
“0.”
n Reverb Send can be set independently for all Voice
parts—Main, Main x Layer, Left, and Left x Left Layer.
Setting range: 0 – 127
When the Voice part is set to Main x Layer or Left x Left Layer, parameters indicated with an asterisk (*) below are set for
each part’s Voice individually.
Octave*
Volume*
Pan (Stereo position)*
Main Set?-->
Octave 0
NO YES
A
B
DC
Main Set?-->
Volume 115
NO YES
A
B
DC
Main Set?-->
Pan C
NO YES
A
B
DC
Detune (Dual mode only)
Reverb Type
Room Simulates the reverberation of a room.
Hall1 Simulates the reverberation of a concert hall.
Hall2 Reverberation is slightly longer than that of Hall 1.
Stage Reverberation suitable for a solo instrument sound.
Plate Simulates the characteristic sound of a plate reverb.
Reverb Send*
MainxLayer Set?-->
Detune +3
NO YES
A
B
DC
Main Set?-->
ReverbType Hall1
NO YES
A
B
DC
Main Set?-->
ReverbSend 10
NO YES
A
B
DC